Design utilizes wire ropes in conjunction with a single hydraulic jack to lift the elevator at a 1:2 ratio. The platform is supported by a cantilevered car frame with the jack, rails, and roping located on one side of the hoistway.

• Available with higher travels up to 80'-0"
• Allows for front, rear, and side openings
• Allows for glass walls on sides where equipment is not located
• Rail bracket attachment only on one wall
• Jack hole is not required - Eliminates cost for drilling and reduces the risk of oil contamination
• Oil requirements are minimized with the 1:2 ratio

• Larger hoistway size required
• Platform depth limited due to cantilever design
• Only available with low capacity elevators (2500 Lbs or less)
• Governor access door is required in overhead unless special governor is provided

These specifications cover all products and will require editing to meet your project requirements.