 |
CANTILEVER IN-GROUND ADVANTAGES/DISADVANTAGES
Design utilizing a single hydraulic jack, which is located under the platform and installed into the ground. The platform is supported by a cantilevered car frame with the rails located on one side of the hoistway.
Advantages:
- Available with higher travels
- Allows for front, rear, and side openings
- Allows for glass walls on sides where equipment is not located
- Rail bracket attachment only on one wall
Disadvantages:
- Larger hoistway size required
- Platform depth limited due to cantilever design
- Only available with low capacity elevators (2500 Lbs or less)
- Drilling of hole to accommodate jack required. Hole depth is typically travel plus 5 feet
- Possible contamination of oil into ground (PVC recommended to prevent contamination)
These specifications cover all products and will require editing to meet your project requirements.
Cemcolift can provide standard sizes (as shown in chart below) as well as Non-Standard or Custom sized elevators. Please contact us to design a Non-Standard or Custom sized elevator. |
CANTILEVER IN-GROUND DRAWING DOWNLOADS
|
| DWG # |
CAPACITY |
OPENINGS |
TRAVEL
UP TO |
INSIDE CAB |
PLAN VIEW DRAWING |
SECTION VIEW & MACHINE ROOM DRAWINGS |
| CIG1 |
2000 |
Front |
70'-0'' |
5'-8'' W x 4'-3'' D |
DWG/PDF
|
DWG/PDF
|
| CIG2 |
2500 |
Front |
70'-0'' |
6'-8'' W x 4'-3'' D |
DWG/PDF
|
DWG/PDF
|
| CIG3 |
2500 |
Front |
70'-0'' |
5'-0'' W x 5'-0'' D |
DWG/PDF
|
DWG/PDF
|
| CIG4 |
2000 |
Front & Rear |
70'-0'' |
4'-3'' W x 5'-8'' D |
DWG/PDF
|
DWG/PDF
|
| CIG5 |
2500 |
Front & Rear |
70'-0'' |
4'-6'' W x 6'-8'' D |
DWG/PDF
|
DWG/PDF
|
| CIG6 |
2500 |
Front & Rear |
70'-0'' |
5'-0'' W x 5'-0'' D |
DWG/PDF
|
DWG/PDF
|
| CIG7 |
2000 |
Front & Side |
70'-0'' |
5'-8'' W x 4'-3'' D |
DWG/PDF
|
DWG/PDF
|
| CIG8 |
2500 |
Front & Side |
70'-0'' |
6'-8'' W x 4'-3'' D |
DWG/PDF
|
DWG/PDF
|
| CIG9 |
2500 |
Front & Side |
70'-0'' |
5'-0'' W x 5'-0'' D |
DWG/PDF
|
DWG/PDF
|
|
|
Hydraulic Equipment
